Fiat EGR Gasket for a 150 CDTI

[marley]

Mine has been fitted for 10,000's of miles with no faults or issues. Car is 2006 1.9cdti 150.

Edit: I only fitted the large square one.

[AntSSSS]

There was a software update for the EGR wasn't there, maybe the settings in that are very fine (to help with the issue) and the gasket reduces airflow too much for the new settings? (just guessing to be fair).

All I can think of too - and makes sense..........

[MacccGyver]

Put this on my SAAB 1.9tid and no enigme management light.

[lofty]

Pick mine up on sat so will find out this weekend.

[Ian S100]

I've just fitted the Fiat mod I bought from AntSSS & happy to report the car is running fine without any warning lights - the manifold/egr was replaced a couple of months back & although it was black inside the egr it's just on the surface with no accumulation - the boost sensor was cleaned out Wednesday & that was filthy

[Tigger]

Anyone got a Fiat part number for this?

I went in to ask for one and instead of getting a blank plate I got a blank look

Cant you just clear the fault code?

[Ian S100]

The one I fitted is P/N 55225287

Not without the appropriate equipment but it will clear itself after about 25 starts I think

[yzf1kr]

Fitted plate to 05' Vectra Estate.

No problems.

[markm]

Got mine to fit, I've run a few jars of Forte in the last two tanks of fuel and was going to get some 10K Boost or EGR3 from Wynns to finish off the internal clean before I fit the gasket,

how long will it take to fit ?

[Dan_BlackSRi]

Got mine to fit, I've run a few jars of Forte in the last two tanks of fuel and was going to get some 10K Boost or EGR3 from Wynns to finish off the internal clean before I fit the gasket,

how long will it take to fit ?

Very quick job, about 15 mins to remove and refit with the new gasket.