Snowflake Center Cap Advise?

[Leemarksmith]

I'm looking to put some domed badges over the griffin? Any ideas how best to do it?

Only just realised there hollow once you pop the griffin out, assumed there would be a backing plate...

So grind the full plate griffin insert flat, trim the griffin internal's (domed badge sits within then) or custom up a thin plate insert with domed on top?... Bit lost at min

[paulvectrac]

the griffin and the circle piece come of lee so you coukd just remove tthem and add the domed ones

[Leemarksmith]

Do they, how, clip or brute force lol

[david-bell]

Look on the back there is 2 little spring type washers that just pop of with a screw driver then just pull the Griffin of then you have a flat surface to bond on to

[Leemarksmith]

Brilliant, cheers lads

[Dan_BlackSRi]

Brilliant, cheers lads

These the OPC ones? Would love to see these when done

[Leemarksmith]

These the OPC ones? Would love to see these when done

Yeah there the ones, should be getting them made this week