Anyone know how to check the MAF sensor power supply or Voltage supply as thats what's come up and a Solus Scanner.
And does anyone know what kind of reading i shud get when i manage to check it? my cars a 2.0DTI 54Reg
Anyone know how to check the MAF sensor power supply or Voltage supply as thats what's come up and a Solus Scanner.
And does anyone know what kind of reading i shud get when i manage to check it? my cars a 2.0DTI 54Reg
- Ignition OFF
- Disconnect wiring harness connector from:
B69 Air Mass Meter- Ignition ON
- Measure voltage between the following terminals:
B69 Air Mass Meter
Wiring harness connector (wiring harness side) terminal 2
&
B69 Air Mass Meter
Wiring harness connector (wiring harness side) terminal 3
NEEDS TO BE GREATER THAN 11v
Then:
Measure voltage between the following terminals:
B69 Air Mass Meter
Wiring harness connector (wiring harness side) terminal 4
&
B69 Air Mass Meter
Wiring harness connector (wiring harness side) terminal 3
GREATER THAN 4.8v
Maf voltage errors are normally just down to them not having the connector fitted properly. Try reseating the connector, I searched this error a while back and this was advised of this and it worked.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks