rear cupholders :)

[kenp]

Hi guys

i need some help from you that have the rear cupholders in the rearbench. As ive just got one to mount on my own..

but i needs the following messurements (atleast)

Hight, with and depth of the hole that the rear cupholder is in.

messurements to there the hole is located (middel of rearbench isnt much help).

Ive supect that your have a "extra" steel wire going thouh the rearbech to where the cupholder holds on to.. and its that i really want to find before cutting ect... would be quite expencive if i do it wrong...

[glenboy]

Will try tomorrow for you Ken.......

[kenp]

maby need to say i need it in CM and MM not inches please.. as a UK inch isnt the same here...

[bigmac]

You mean my 7inches is 5 inches to you

[fingers66]

You mean my 7inches is 5 inches to you

Yours is only 7 inches ..... sorry to hear that m8

[bigmac]

Thats limp

[Ste]

From the floor?


If you lie down.

[bigmac]

Thread has been hijacked sorry Ken will get figures you need in a bit if no one posts before me

[kenp]

well a Inch here is 2,6145833 cm and a UK inch is 2,54 cm... would make some difference

[sanjeevgangar]

Hi guys

i need some help from you that have the rear cupholders in the rearbench. As ive just got one to mount on my own..

but i needs the following messurements (atleast)

Hight, with and depth of the hole that the rear cupholder is in.

messurements to there the hole is located (middel of rearbench isnt much help).

Ive supect that your have a "extra" steel wire going thouh the rearbech to where the cupholder holds on to.. and its that i really want to find before cutting ect... would be quite expencive if i do it wrong...

Can u please put HOW TO on this mod please because I need to do this mod soon.