Anybody ever replaced door pins on a Vectra? How easy are they to do?
Anybody ever replaced door pins on a Vectra? How easy are they to do?
as far as I am aware they just pull off....push the new ones on, can anyone confirm ?
not quite....
get a small screwdriver and prise out the red segment on the VX pin, that will release the shaft and let the door pin pull up and off..
then using an allen key, tighten your new alloy pins back on to the steel rod at the height you want them to be at
Absolute doddle m8 less than 10 mins to do all 4.
Get a tiny screwdriver and prise the red clips out of the original pins, then the plastic pin just lifts off.
You're left with a metal stalk.
Put the new pin on the stalk and tighten the grub screws to secure. Lock door to check the position of the pin. Adjust if necessary.
Stand back and admire
Edit: beaten by the spannergod
As above. Piece of ****. Even I can do it. You may have to chop the rear ones down a bit as the rod is at an angle which means they sit higher than the fronts ones.
Only if it bothers you obviously.
Thanks all
And if you're a bit of a perfectionist and don't want the grub screws showing - http://www.vectra-c.com/forum/showthread.php?t=20081
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks