Question when replacing front wheel bearings on veccy

[automan]

Hi just done both sides of my vectra c front wheel bearings.Question is ,is it ok to put wheel bearing grease on the driveshaft splines to stop any rust jacking for the future? I already added some and hoping it won'tcause any issues with the abs sensor.Any advice appreciated.

[northpole]

Absolutely no need for it... I never did it on any car the tolerances are so small there will be only surface rust nothing that'll bind the spline to the bearing.

[automan]

Absolutely no need for it... I never did it on any car the tolerances are so small there will be only surface rust nothing that'll bind the spline to the bearing.

I have already done it . Should i leave it or try and undo hubnut and try and clean it off.Will it cause any issues if left this way? thanks for reply.

[northpole]

No you can leave it, it's not a problem as long as you torquethe lot up to spec.

[northpole]

Double post...

[automan]

No you can leave it, it's not a problem as long as you torquethe lot up to spec.

Cheers yes i torqued it all up to spec .will leave it then.