-
28th December 2019, 00:43
#1
New Member
Fried electrics?
Hey everyone, I've been sort of wiring up my heated seats, seeing as its xmas and I wont be needing the car I decided to make up a loom for them as the car didnt have one. I already bought the correct colour wires but I am still waiting for delivery of the pins. So while I'm waiting for the pins I was putting the wires where they are meant to be ready for the pins arrival so I can just crimp on the pins, shove them in the plug and off I go.
Well in my wisdom I unplugged the big plug in the passenger footwell to have a gander at where the pins would go. I ignored the good advice of every forum and didn't disconnect the battery. Now once I've plugged back in the footwell plug the car wont start. When I put in the key and turn to the on position the headlights come on and wont turn off, the outside temperature is displayed as being -40, the doors wont lock or unlock, the boot wont open and even worse, my cheapo ebay opcom isnt recognized so I cant even see how many fault code I've triggered.
Any pointers would be greatly appreciated.
Thanks
Dave
-
28th December 2019, 19:04
#2
My first thoughts would be get your OBD code reader working.
-
28th December 2019, 20:38
#3
Have you tried the ole reboot method by disconnecting the battery for 10 mins
-
Post Thanks / Like - 1 Thanks, 0 Likes
-
28th December 2019, 21:37
#4
New Member
Nice one, last night when I was trying to reset it by disconnecting the batt I was only leaving it disconnected for a minute, if that. However just tried leaving it disconnected for 10 min plus and it has worked. Panic averted. Thanks for the tip.
-
Post Thanks / Like - 1 Thanks, 1 Likes
-
28th December 2019, 22:19
#5
Was going to say, Ive done this a fair few times to a couple of Vectra's with no issues so did think it was odd it all got messed up.
Vectra VXR estate 2007 Sapphire Black
Teapot Tuned 255/300
Eibachs B8's, fully loaded factory options
Tech2 & MDI diagnostics + SPS
Bookmarks