Geometry Settings after Lowering

**yoclick** · 27th June 2011, 13:36

Hi,

Fitted a set of PI -30mm lowering springs and need to get the car aligned in the next few weeks. I called up a local place with the hunter equipment, but when I stated it was lowered, they said they could only use the manufacturers recommended spec. Since its been lowered, I presume these settings are no longer valid? If not could someone please let me know what they should be, so I can give them to the garage directly?

Cheers

**Ziggy** · 27th June 2011, 14:05

I want with OPC/vxr settings, but will be interested to see the response

**lee gsi** · 27th June 2011, 18:14

Mine was set to the 'Sports' settings.

**Ziggy** · 28th June 2011, 09:20

Going to bump this incase anyone else has an opinion

**Ziggy** · 28th June 2011, 09:21

Originally Posted by lee gsi

Mine was set to the 'Sports' settings.

Sports will be sri, so only 15mm lower not 30mm

Also if running spacers should this effect the settings used?

**gtr1000** · 28th June 2011, 13:40

Yet again, Hunter's website does NOT endorse garages or the muppets using their equipment, they simply state where their gear is installed.

If you want someone who knows about geometry, find your nearest garage here http://www.blackboots.co.uk/tyre-fitting-centres.php.

Also have a read up on the techy stuff before you take the car in to anywhere so you don't get fobbed off with bull****.

**Ziggy** · 28th June 2011, 14:04

Originally Posted by gtr1000

Yet again, Hunter's website does NOT endorse garages or the muppets using their equipment, they simply state where their gear is installed.

If you want someone who knows about geometry, find your nearest garage here http://www.blackboots.co.uk/tyre-fitting-centres.php.

Also have a read up on the techy stuff before you take the car in to anywhere so you don't get fobbed off with bull****.

Surely though in the same way there are settings for a standard vec etc Eibach should have released settings for there setup?