Fitting foglights to facelift vectra life

[Steven T Davies-Moss]

so u did'nt use ur fusebax at-all then.. just an in-line 15A fuse ... aha

[Tony W]

so u did'nt use ur fusebax at-all then.. just an in-line 15A fuse ... aha

Yes Steven...

I debated whether to use the existing 'prewired' plugs shown in the picture in my posts with the front bumper removed, tracing the black 'power' feed to each plug back into the wiring harness('s), cutting each one at a convenient point in the wiring harness('s), fitting an uninsulated spade connector to each fog lamp feed; then diverting the cables to the relay male spade terminals....(temporary green cables are shown in the picture)..finally insulating the 'black wiring from the fuse box..
with the brown 'earth/ground' cables from the plugs to be utilised.

However, I decided against this and got two more fog lamp plugs...with as much wiring attached as possible, from a scrap yard off an Astra..leaving the existing plugs in tact & tied up out of the way.....new plugs are unavailable as loose items from the dealers I understand & I've not found any suitable on Ebay....The ones on there look similar but the locating clip is in the wrong position..

Note the guide 'rail' & locating clip positions which are necessary to fit into the fog lamp socket & hold it secure...(they will be 'cleaned-up' prior to fitting).....



Hope it helps.....

Cheers