A question for you guys that have fitted rear parking sensors in the bumper.
How did you route the cables into the boot?
Is there a grommet to put the cables through?
A question for you guys that have fitted rear parking sensors in the bumper.
How did you route the cables into the boot?
Is there a grommet to put the cables through?
Hammer and a cold chisel mate
Ian there is a grommet into the spare wheel well matey just pop the wires through that ........Thats what i did !!!!!
Back in a V6 !!!!!!!!!!!! And lovin it !!!
I had aready used the spare grommet for my towbar so I had to drill a fresh hole using a holesaw and fitted a grommet. Also, just to let you know, I did not have to remove the bumper to fit the sensors - used measurements from a 'how 2' on this site.
before anyone jumps in I meant towbar wiring, not the actual towbar!
split the gromet where the number plate light cable's go through mate, then fit a new one, that's what i did
Thanks Guys
I routed mine up behind the left light cluster and in through the light aperture.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks