Will a 19" snowflake fit into a signum wheel well as a spare.
Will a 19" snowflake fit into a signum wheel well as a spare.
As long as you taek put the Polystyrene thing at the bottom i believe it will...
I know a 215/50/17 will fit in the Wheel Well of a Vectra.
I think the signum is diferent though, and it wont iirc
O well. So what would you suggest as a spare if your useing 19"wheels. Don't like the idea of useing the skinny thing that i have at the moment.
Shan
You coold always get a piece of MDF measured up and raise the boot floor slightly to make sure there was no Wheel shape in the carpet, Obviously cut the hole for the spare wheel, you could even make it so the wheel is covered by the cut out bit of MDF, and put a small flatish handle on it so you can lift the lid off to expose your spare wheel..
but you'd have to scrap the lashdown points in the floor....as the bolt down through the carpet..and the 3 other fixings up the 'front' of the boot....
Can't deepen the wheelwell either, as it's dead tight to the exhausts..
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks