3.2 fault codes

**rayvo-gsi** · 18th February 2009, 02:43

Anybody know what these fault codes are 1614,1616,1613.I did the brake and accelarator thingy and came up with these.

**stevedee3** · 18th February 2009, 10:18

P1613 = Immobiliser no or wrong signal
P1614 = Wrong transponder key
P1616 = CIM wrong environment identifier

**CDXI_2003_AUS** · 18th February 2009, 14:26

If they are the faults, it looks like someone changed the CIM over from the original one and didn't get it tech 2'd into the car

**spennny** · 18th February 2009, 14:37

Originally Posted by rayvo-gsi

I did the brake and accelarator thingy and came up with these.

What brake and accelarator thingy

**CDXI_2003_AUS** · 18th February 2009, 14:41

It's where you hold down the accelerator and brake then turn your car on (not start

) and you can read out your fault codes. Works for the 3.2 Veccy C and the 2.6 Veccy B. Link to thread here. http://www.vectra-c.com/forum/showthread.php?t=44548

**spennny** · 18th February 2009, 15:03

I see,

Doesnt work on the 2.2 though

**Tadpole** · 18th February 2009, 15:27

Originally Posted by spennny

I see,

Doesnt work on the 2.2 though

That saved me trying it, thanks m8.

**rayvo-gsi** · 18th February 2009, 18:27

surely if it had not been tech2 the car wouldnt do anything ie dash etc.

**stevedee3** · 19th February 2009, 11:14

Have you had any problems starting the car?

**rayvo-gsi** · 19th February 2009, 13:19

Originally Posted by stevedee3

Have you had any problems starting the car?

Yep sometimes the padlock symbol comes up on the dash and the car is dead (imobiliser no cutting in)i have to keep putting the key in and out and eventually it will start.I have also noticed that when i put the key in the ignition and the padlock symbol shows if i then press the unlock button on the fob the car will start.