aiflow meter help please.........

[vectra gsi 3.2]

right guys need a bit of help here, i"m looking to remove the back half of the airflow meter of the housing part, its a tork bit, but it has a bit in the middle so i is stumped as to get it of......???? i"m not fitting a cone filter btw, so i canny just rip it of....it has to go back on the way it came off......

[Handyandy-UK]

Those require a 'security' bit to remove properly, unless you have something like a Dremel tool and can either cut a slot in the head or drill/grind down the centre pin without damaging the torx splines.
Security bits kits can be picked up at all manner of tools suppliers.

[vectra gsi 3.2]

Those require a 'security' bit to remove properly, unless you have something like a Dremel tool and can either cut a slot in the head or drill/grind down the centre pin without damaging the torx splines.
Security bits kits can be picked up at all manner of tools suppliers.

cheers fella can u buy them seperit ok..........
i have loads of tork bits so don"t wana buy a complete new set.........

[Handyandy-UK]

How's this appeal to you ?

http://www.buyspares.co.uk/product.p...FYbHtAod7SsASw

[farley2708]

you can have a lend of mine Barry,you want me to drop them down to you

[vectra gsi 3.2]

you can have a lend of mine Barry,you want me to drop them down to you

ur the man nigel.............
one of them will do me job just fine bud...........

[farley2708]

can drop them off with you tomorrow......................she wants to go to Ikea!!!!!!!!!

[vectra gsi 3.2]

can drop them off with you tomorrow......................she wants to go to Ikea!!!!!!!!!

i will give u a buzz now nigel.........cheers.........