evening all, would like to clean my boost sensor on my 3.0 v6 cdti signum(03) does anyone know where it is?if possible a picture! thanks all
evening all, would like to clean my boost sensor on my 3.0 v6 cdti signum(03) does anyone know where it is?if possible a picture! thanks all
yes but I cannot do pics as I don't have the car anymore.
Remove the black plastic engine cover, its at the back right hand side - not too far from the turbo. You will see a black "cable tray" and its partly under that.
Its also hot the word BOOST written on it iirc, mine was grey in colour, iirc its held in with 1 or 2 bolts. Careful when you take it out/replace it as its got a rubber o ring that can get damaged, a small amount of grease on this will help when you put it back.
HTH
thanks for that bud, i read a post from a few days ago from people doing this with good results so wanted to try!
Mine wasn't that dirty but it needed doing. Just be careful that you don't push the crap into the sensor
removed engine cover and i swear i have looked everywhere for the boost sensor and cannot find it! help!
bump! can anyone help?!
As in my post no.2. Its right at the back near the black cable trunking - same end as the turbo.
ABout 50mm square, gray with 2 bolts on it. has the word boost written on it. Its right at the back, near the bulk head.
Post a pic up and I'll put an arrow to the approx area.
Under the red dot
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks