As title, anyone fancy taking there key apart and taking a photo of the board, both sides please. button and then battery side...
A quick measurment or estimation of the board size would be good also
Cheers to anyone who replies...
As title, anyone fancy taking there key apart and taking a photo of the board, both sides please. button and then battery side...
A quick measurment or estimation of the board size would be good also
Cheers to anyone who replies...
Linky may/mot not help?
Interesting reading there G.
I know Glen, I was tempted to do my key but its far too much about for my liking and I dont really have the time!
I just wanted to check if the board in the early vecs matched the flip key, or at least very similar...
To do just like you posted, swap the internals rather then reprogrammed...
I doubt they will be the same mate and the key's aint really meant to be opened, to get into them-I think you have to break them!
Here ya go, mine is only two button but the circuit board fills the whole key anyway.....
Hmmm, non flip keys are bout 26mm long by 24mm wide.
So cant see whay you just cant swap the internals?
anyone think that would be possible, dremmel out bits that need to be and pack put the rest...
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks