I have just replaced a 2.2 z22se engine in a 52 plate vectra c, the donor engine came from a vectra b, i used most of the parts from the vectra c on the donor engine, when i had finished i fired her up and started first time no problem, i had it up in the air on axle stands so i left it running at 1400 rpm for about an hour to check for leaks etc(as i had replaced all of the timing chain gear) it was fine then it made a rumble/rattle and cut out.
when i went to re start it, i got nothing, just a click from a relay in the footwell (passenger side) and the fuel relay in the boot is clicking constantly like a hazard light relay. I have connected the code reader but it is now telling me it cannot establish a link to the ecu and the engine management light on the dash will not light up even when the ignition is just turned on. i did not change the knock sensor oil pressur/level switch or anything else that was bolted into the head or block
There is plenty of fuel
battery is fully charged
oil is at max
engine will turn freely by hand and also if i feed a live directly to the starter it turns over great.
I haven't changed the knock sensor temp sensor, or any sensors bolted into the block they are all from the vectra b
i have given a lot of info here and if anyone can give me the solution to this i will gladly make a generous donation to them, if anyone is in the Lancashire area that would be able to sort it then i will pay whatever it costs, i refuse to take it to vauxhall !!!!!!
please help i am close to suicide with it :-)
Bookmarks