Hi guys
I am very worried that your all going to say valve stem oil seals but here goes !
Car Details
04 Reg Vectra C SRi CDTi 1.9 16v (150)
Problems/Symptoms
1. After the car has been sat for a few hours it pumps out quite a bit of blue smoke on startup. This clears after a few seconds but leaves a smelly pool of blue smoke floating around
2. The car seems to have lost power at lower revs
3. Hesitates/misfires occasionally
4. Sometimes cuts out when pulling up after a drive say at a set of lights. When I put the clutch in it just cuts out.
(Some of these may not be linked)
I have had the car plugged into a OBD and the codes are as follows
P1811 Engine Torque Signal Malfunction
P0190 Fuel Rail Pressure Sensor Range/Performance
Any Ideas ? I was thinking of getting a new fuel pressure sensor first ? Seems logical (cheapest) place to start
If it is Valve steam oil seals is this something that can be done at home ?
Bookmarks