Vectra c Z2.2se I keep getting fault code P0341 which is Cam sensor.
The engine appears to run OK any ideas where to look has the Heynes manual does not mention where i can find the cam sensor or even if it has one, any ideas?
Thanks Martin
Vectra c Z2.2se I keep getting fault code P0341 which is Cam sensor.
The engine appears to run OK any ideas where to look has the Heynes manual does not mention where i can find the cam sensor or even if it has one, any ideas?
Thanks Martin
Have you asked over on the 2.2 forum mate, they'll be able to give you the definitive answer.
Not yet where is it
z22se.co.uk mate. As site dedicated to our engine, for tuning and general running issues.
Help have now replaced Crank sensor and coilpack still keep getting eml light with P0341 fault (Cam sensor) even though the Z22se doesn't have one.
ANY IDEAS
Martin
Did you fix this mate im getting the same problems.
Hi Yes I did fix the fault.
The fault started about a month after a service using genuine parts including changing the spark plugs. To try to fix I Replaced Coil Pack, Crank sensor , Then sent car to U/s stealer's you didn't have a clue and tried to sell me a £600 ECU with no guarantee of it fixing the problem Told them where to put the ECU!!!
Finally found out that the Genuine Spark plugs were faulty, put another set in and all OK so replaced COIL PACK, CRANK SENSOR TECH 2 for no reason!!!!!!!!!!!!!!!!!!!!!!!!
I Hope this does it!!! when i brought this i was told it started when the spark plugs were changed. sounds hopefull!!!
thanks for the reply mate i will write back after changing plugs tomorrow.
Spark plugs I owe you a beer mate! saved me a hefty bill a vaux! Thanks.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks