I need to remove the no holes phone bracket from my Siggy. The car kit was fitted professionaly and the bracket is fitted between the trim and the N/S centre air vent. Any ideas?
I need to remove the no holes phone bracket from my Siggy. The car kit was fitted professionaly and the bracket is fitted between the trim and the N/S centre air vent. Any ideas?
Off topic.
Did I see you on the A38 heading towards Bassets Pole island about 5.15 pm the other day. A black Signum.
Could you remove the air vents then you might see more.
The long strip below the air vents just pulls off, then you will see where the vents are held on by screws, then they just pull out.
Pull the trim off and remove the the torx screw holding the dashmount, should just pull out from the top of the vent. Replace screw and trim.
Wow, that was quick.
Thanks for the prompt replies, I'll see what I can see when I remove the trim.
Yes Ed, It was me you saw near Bassets Pole, I hope my driving was OK
Your driving was ok. "oh" nice looking motor too. We were in the wifes Vectra B. Other wise I would have not seen you. We would have been well past the Island if we were in my motor. The wife drives a little slower than me (we both adhere to the speed limit though).
# Did you stay on the A38, we turned off ontothe A446. Nasty accident on the A446 Tuesday about the time I saw you on the Wednesday.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks