VXR Front Bumper To SRI???

**SRIAdam** · 14th July 2009, 17:12

Hiya, i was just wondering if anyone knew if the Front bumper from the Vectra VXR would fit straight On a Vectra 2.2 SRI (2006) or is there a little more to it than that???
I'll put a couple of pictures to show what bumper i mean and a picture of mine

Cheers

Adam

**Steven T Davies-Moss** · 14th July 2009, 17:38

streight swap M8 ... only need to wire up the headlamp washers if you want them

**Robbie69** · 14th July 2009, 17:54

That will go straight on mate.

**big rich** · 14th July 2009, 17:59

straight forward swap m8, it would look the nuts too

**LEW1S2006** · 14th July 2009, 18:01

Will look great, i fancy doin it myself..have u sourced a bumper yet? If u have how much did u get it for?

**glynn** · 14th July 2009, 18:08

as above fella, kpf1 done this last year

**Big-Pete** · 14th July 2009, 18:49

As said it will go straight on, i've done this myself, You'll also need to extend the foglight wiring, if you look in the reference section you'll find a complete list of parts, you'll find the part number for the foglight wiring extenders in there aswell, the car will look so much better with the VXR front end

**SRIAdam** · 14th July 2009, 20:24

Cheers guys! I didn't think it would be that simple. I haven't yet sourced one and I'm not sure how much it wil cost, I'm not sure if the rear bumper is the same or the side skirts? But after my cobra exhaust is fitted I will be getting that front bumper!

Thank you again everyone for your help

Cheers
Adam

**ditchp** · 14th July 2009, 21:04

Originally Posted by Steven T Davies-Moss

streight swap M8 ... only need to wire up the headlamp washers if you want them

little bit more to it than that i'm afraid, you will also need bigger bottle-pump-washer jet's-pipe work and a tech 2 session and that's if you have the loom and relay/fuse already fitted....

hth