torque settings

[lizard]

I left my Haynes manual at work and need a torque setting please. I need the setting for the bolts that hold the two halves of the caliper together, not the mounting bolts. cheers

[Duncan]

You mean the caliper to the carrier?

[lizard]

these 2 Duncan

[Duncan]

So that's the carrier to hub bolts and the caliper to carrier bolts then?

[lizard]

I'm thinkin so Duncan....

[lizard]

also while your here i'll ask you another question if thats ok. Can the calipers and carriers be laquered safely....

[rushy]

Guide bolts 30nm
Caliper mounting bolts 230nm

Thats for the 285's, Haynes doesn't list 314's. HTH

[Duncan]

I'm thinkin so Duncan....

It must be from looking at them. If you've only removed the bolts needed to get the calipers and carriers off then that's all you would have removed - four bolts. Gimme a sec and I'll get the details for you. The carrier to hub is FFT, the caliper to carrier is not a great deal. One sec...

also while your here i'll ask you another question if thats ok. Can the calipers and carriers be laquered safely....

Yep, just the same as painting. Just don't get it into the friction surfaces/rubber boot areas.

[lizard]

they will all be laquered before all guide bolts, boots and bleed screws are fitted...

[rushy]

Guide bolts 30nm
Caliper mounting bolts 230nm

Thats for the 285's, Haynes doesn't list 314's. HTH

Looking through !!! it doesn't say any difference to 314's