vxr rear lower insert

**trickysvec** · 16th February 2009, 00:27

just need a bit of advice.how is easy is it to spray and fit the vxr rear lower bumper insert to go on my 55 plate sri.and what would look best colour coded or satin black like the original insert.

**jamesr** · 16th February 2009, 01:28

Easy!

Simply remove the push fittings on the underside of your SRi one.
Pull off the grey Insert, and push in the new one.

I think they look quite good painted in black IMHO.

**big rich** · 16th February 2009, 02:47

dont be rough pullin the old one out as they snap on the top very easy....lye under the back of the car and prise the clips to remove it, when fitting the new one it will feel very tight but just give it a bit of a tap and it should just pop in to place

**Tadpole** · 16th February 2009, 04:33

Originally Posted by big rich

dont be rough pullin the old one out as they snap on the top very easy....lye under the back of the car and prise the clips to remove it, when fitting the new one it will feel very tight but just give it a bit of a tap and it should just pop in to place

...