Driver side door switch.

**Quaternion** · 8th January 2009, 14:34

Hello,

I'm trying to retrofit rear electric windows (vectra 2004). First made sure the pins were there then took of the door cards behind off. Replaced the looms, attached the motors and switches. Replaced the drivers switch (so it has front and rear control). Went to the garage for tech2. Now the rear windows going up and down from the switches behind. But when i want to operate the rear windows from the front control, no matter what position the middle switch is, only the front windows going up and down. Also the knob to lock the rear windows doesn't work. So it looks like the Tech2 isn't correctly done and they told me it can't be done. Does someone knows what the garage is missing during programming? Now i paid 100 Euro (labor) for something that's, in my opinion, isn't done properly.

Thanks

**glenboy** · 8th January 2009, 14:41

They need to enable it using the Tech2,a few ppl have had this problem before,think it was IanHighlander and a few others,need to go back to them and explain,they need to enable the new switch to work the rear windows and locks.........

**Quaternion** · 8th January 2009, 21:00

Originally Posted by glenboy

They need to enable it using the Tech2,a few ppl have had this problem before,think it was IanHighlander and a few others,need to go back to them and explain,they need to enable the new switch to work the rear windows and locks.........

Thanks, wil do that and let know the outcome of it. Do you happen to know wich menu they have to go. They looked at the DDM, PDM and BCM.

**glenboy** · 8th January 2009, 21:26

Sorry no.....

**Quaternion** · 11th January 2009, 22:39

Anyone else? Could it be the front door loom? If that's the case, i'm also thinking about folding dimming mirrors, so the loom should be replaced then anyway (i think). Does someone know what partnumbers i should use (It's an Opel 04-2004 with the steering wheel on the left)? Any help is much preciated.

**Quaternion** · 11th January 2009, 23:38

*UPDATE*
Just checked what will happen if i open/close the windows with my car key. Surprisingly all windows open and all windows close. So i now think they definitely missed a setting. Correct me if i'm wrong.

I also found this on the forum HERE:

Originally Posted by holtie

addition to my previous post - Another thing to watch out for if trying to put all wires in is the ones that connect to the front switch. From the haynes manuel there seems to be an extra 2 from the switch to the door module - 1 for the fromt/rear switch and 1 for the child lock.

**Duncan** · 11th January 2009, 23:44

If all the windows are now opening off the key, then it definitely sounds like they haven't programmed the new drivers switch module in fully. In reply to your earlier question I'm pretty sure it's DDM and possibly PDM that are involved. Don't think BCM is part of the programming. I'd ned to dig my kit out to see if the windows are linked at all to the BCM but I don't think they are.