Hi guys
anyone got any ideas where the fuel filter is on a dti 2.0 signum? im looking to change it today
cheers
Hi guys
anyone got any ideas where the fuel filter is on a dti 2.0 signum? im looking to change it today
cheers
If it is like on mine though mine is a 3.2 v6. I think you will find it at the rear by the back wheel.
It is on the right hand side.
ill take a look at that in a mintue...having a big problem removing the sump nut right now...it must have been tightened with an impact wrench who ever dd it last time!!!!!!!!!!!!!
The fuel filter on a 2.0 DTI should be at the rear of the engine compartment adjacent (right) to the coolant expansion tank. I think that you may have to bleed the system after changing the filter.
any body got a how to for it?
According to the Haynes on1.9 engines do this:- to bleed the system switch the igntion on three times (do not start engine) for about 15 seconds each time, it SHOULD now start. If it fails to start wait for a few minutes then repeat operation. But on 2.0 and2.2 engines a Bosch VP44 pump is used, a bleeder kit VX part number KM-948 will be required along with a long operation, takes up about half a page!!! It also states that in theory a few cranks of the engine may work, but this may also result in damage to the pump and that it is up to the owner. Good luck.
Last edited by carpet; 21st December 2008 at 17:07.
I changed mine a few weeks back , just undo the torx bolt , remove bolt and then take out filter , replace the filter. I did loose a bit of fuel maybe 100ml . Once back together she turned over after half a dozen attempts. BTW I have the 2.0dti Vectra
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks