has anyone fitted reverse sensors to a vectra esate and did you remove the bumper? also is there any grommets for the wiring to go through?
has anyone fitted reverse sensors to a vectra esate and did you remove the bumper? also is there any grommets for the wiring to go through?
think all bumpers have the markins on the back for them
you don't need to remove the bumper. Sensors go on the black trim. No drill marks so make a common sense choice. Take a look behind before you drill as there is a solid metal bar which you don't want to go near.
From memory there is a rubber grommet covering a suitable hole, just pop underneath for a look then feed the wires through and feed towards the fuse box on the nearside.
Pictures might help....Mine by the way.....http://www.vectra-c.com/forum/showth...t=29087&page=2
When I fitted them to my 2007 XP estate the guide markers were stamped in the back of the bumper, and there are a few well placed gromets into the boot.
i have had a look at the how toos but can someone please confirm which wire is the reverse light feed on the rear electronics board,also a picture of the wiring connevtor would be appreciated or a link to maplins so i can get it later,many thanks
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks