losing power

[lacom]

I have 2004 Vectra with 2.2 DTI and have problem: loosing power, and rpm can't get more then ~2700. Exhaust emission lamp is lightning. If it's happened, then there can help restarting engine only. It's happening more with warm engine.

I get 2 codes: p0105 and p1105

Before I changed Air flow meter.

Now changed MAP (used - I'm not 100% sure about working) and repaired Alternator, but It didn't help.

I discovered there was bearing ball in MAPs tube, to close tube

[steve]

P0105 Manifold Absolute Pressure/Barometric Pressure Circuit Malfunction

P1105 Dual Alternator Upper Fault

HTH M8y

[lacom]

As I said:

Changed MAP (used - I'm not 100% sure about working) and repair Alternator, but It didn't help

Today I'll recheck the codes.

[steve]

yeah recheck incase its a new fault code. Also maybe it didnt help because

''(used - I'm not 100% sure about working)'' Just a thought

[lacom]

if I'm correct MAP is for turbo.

But why I can't get rpm higher then 2.7-2.9k? I'm driving like on 0.9 diesel motor with one cylinder, without turbo. I can make drag race with school bus - he will win.

[steve]

Is it going into limp home mode?? Just wondering if it can be something as simple as o2 sensor or EGR value

[lacom]

Local Opel dealers are so smart as died polecat. I'm using my own cable to computer, but it showed just those mistakes. Today will check again.

[lacom]

Is it going into limp home mode?? - how to check?

[steve]

Car with a spanner through on your engine management screen on your speedo in the rev counter.

[lacom]

No, this is not showing. Some time ago then Exhaust emission lamp switched off , simetimes showed "Car with a spanner through". But not now.