tow bar photo

[graememk]

has anyone got a in the boot photo of there tow bar fitting please

[ditchp]

it just so happen's i have mate, give me 5 to upload my pic's

[gsxrster]

why do u need a pic
the plate on the fixing sits onto the boot floor ( after the insulation has been cut out)
cant be seen after carpet has been replaced

[ditchp]

here you go matey, taken while finishing mine off, there are small dimples in the floor pan where you are to drill through into the chassis leg area/rear panel, dead easy realy just make sure once you have drilled them and put the sleve's in you don't knock the sleves over into the chassis leg

[graememk]

my brinks tow bar has a large plate that goes under the car i then have 4 bolts 2 either side, it has a large plate and a smaller plate and i would just like to know weather the large plate goes in the boot or under the car.

[gsxrster]

my brinks tow bar has a large plate that goes under the car i then have 4 bolts 2 either side, it has a large plate and a smaller plate and i would just like to know weather the large plate goes in the boot or under the car.

does the plate not come attatched to the bolts?
mine did , therefore it goes through the boot and the nuts attatch to the underside .
as per pics above

[Green Growler]

taken while finishing mine off.

Hey m8, was any sound deadning removed from the boot floor, because it doesn't look like it was in that pic.

[graememk]

this is what i have, the plates with the bolts going through them should the larger plate be ontop or below ?

[Green Growler]

Yep, definitely, large plate on top, onto the boot floor, and don’t forget to remove the sound deadening from directly under the plates.

[ditchp]

Hey m8, was any sound deadning removed from the boot floor, because it doesn't look like it was in that pic.

i cut around the plate after first propper pic, got most of it off bar some small bit's