rebuild project day 6

[glynn]

well, im one step closer. the rear quarter is fully on, cut the new one down in size as i didnt need all of it, and layed it over lapping some of the old one to cut through the two pieces together so the will line up nicely . then it time to clamp to into postion again after the bare metal was sprayed in zinc to stop it from rusting. then it time to spot weld around the door shut and rear 1/4 window and the rear light panel. then seem weld the cuts in three places as you eill see in the pics got to sand down the seem welds tomorrow and apply some filler to wear its needed

[Baz07]

Coming together nice, keep it up...

[scottyd]

the patience of a saint keep up the good work

[vectra 120]

Top job m8 well done

Steve

[glynn]

thanks for the comments guys

[scottyd]

i dont even wanna tackle a scratch on my wing and look at what your doing.lol

[ditchp]

matey, keep up the hard work, roll on billing

[glynn]

matey, keep up the hard work, roll on billing

i have a funny feeling its not going to be done by then but you never know

[Stevel]

Great work Glynn. Would love to see it at Billing. Fingers crossed.

[ditchp]

i have a funny feeling its not going to be done by then but you never know

finger's crossed for you matey