New throttle body plate(s)!!

[Vid]

My old man kindly did a technical drawing of a plate that is needed for my new 2.0 SC throttle body to fit, took it to work and had some plates laser cut for me!

I needed to have more than one plate as otherwise the body of the TB presses up against the runner on the inlet manifold (this wouldn't be a problem on the normal 2.2 manifold), so I have had 5 done! With 4 spares so I could drill the holes myself if the other plates were out for some reason, but they are fine - yay ! I have ordered a length of tubing for inlet pipework, with a fitting welded into it for my breather hose. Once that is here I need to get it squashed a bit so it will fit right, then we are good to go for the remap hopefully!!

[rushy]

Mmm, more shiny bits. You should have got more made mate and punted then on Z22se like the ECU brackets. So when you fitting the TB then? As you might have seen on your other thread I have something in mind.........1 day to go

[Vid]

Is that about the K&N Apollo??

Might be this week sometime for fitting the TB?