Tonight Im going to Bond My Estate Boot Spoiler !! Any Tips ?

**DeanF** · 16th June 2008, 16:35

Tonight i plan on bonding my Estate Roof Spoiler on

Any Tips or Suggestions as to best practice ETc ??

It is a Geniune Irmscher one, But still is not a perfect Shape/fit, It curls up on the Narrowest part either end (Narrow bit that sit's next to the C-Pillar) & will more than likely need weighting down...
Cheers

Dean

**mushy2007** · 16th June 2008, 16:37

Do you have garage?

You could leave the boot open and put a tension strap around the spoiler and boot and leave over night.

**shan** · 16th June 2008, 16:38

First make sure the bonding agent you have is OK IE not gone all ready mine had

Plenty of masking tape to hold it in position.
Just stick plenty of bonding agent on as it will not be coming off anyway.
Good luck and plenty of it.

**DeanF** · 16th June 2008, 16:45

Originally Posted by shan

First make sure the bonding agent you have is OK IE not gone all ready mine had

Plenty of masking tape to hold it in position.
Just stick plenty of bonding agent on as it will not be coming off anyway.
Good luck and plenty of it.

Yes. I do have a Garage, The Estate just sneaks in

I'll check the Irmscher Bonding has not gone off !! Although i do have a new tube of Tiger seal !! I was concerned that the spoiler would end up lifting before cured & the have a Mighty gap for Small Rodents to nest in

Cheers

Dean

**shan** · 16th June 2008, 16:48

I don't think it will curl up to make a mouse house. LOL
Genuine Irmscher stuff fit's very well and you should have no issue's. Just stick plenty of tape on it to hold it.

**JuzzyD** · 16th June 2008, 18:02

Just be careful that its not taped down to tightly over the centre brake light position otherwise your rear wiper might catch it when it sweeps past (like mine did after we fitted it).