BSR badges - yay or nay?

[Duncan]

Oh Lordy!, it's another badge thread!!

Ever since I got my Stage 1, over three years ago, I've been undecided about this! lol

The Stage 1 came with one large BSR badge which I toyed with putting above the 2.0T on the back, but always thought it was just a bit too big and didn't keep in fitting with the subtle/sleeper look of the car.

The Stage 3 then came with another larger badge, but also two smaller ones that they'd started to do which I thought may be more my style - but they've sat in the box since I got them , so today I had a shufty at a couple of possibilities.

Large badge on rear


Small badge on rear


Small badge on wing...


...and I'd more than likely remove the Elite badges


When I first tried the large badge on the back way back, I thought it was too big, too obvious, but now I'm not so sure!, I think it looks kinda okay? TBH I'm still not sure on it The small badge I think is too small, just looks odd? What would've been perfect was one where the whole badge, including the red swoosh, was the width of the 2.0T - but not an option.

Sooo, I'm maybe tempted to go for large badge on the back (still not sure) and a small one on each wing. Waddya all think? Added a poll with the various options.

EDIT: Added another option - small badge on rear and both wings as I can always get another small badge from BSR

[Green Growler]

Don’t like the big badge on the back, yuk, lol.
But the little'ns on the wing are spot on, even better when you get them straight and remove the Elite badges.

Edit: You need more poll options, lol.

[Caterman]

If the fonts were the same then the big one put before the 2.0T would look ok.

Deffo remove the ELITE and put the small ones above the repeater

[john_k_sri]

I've gone the whole hog you might say. Big badge above the '2.0T' at the rear and small badges above the 'SRI' on the wings. The 'Edition 100 ' badges are on the driver and front passenger's doors. I have the comfort of knowing no-one else is likely to do the same. Well, it suits me.

[signumboy]

Stuck mine on left back ..covered small mark left by original signum badge



to many badges are a nono

[Duncan]

Don’t like the big badge on the back, yuk, lol.

lol, don't worry - I'm still not sure on the large one on the back either!

But the little'ns on the wing are spot on, even better when you get them straight and remove the Elite badges.

'twas just a quick stick on with some blu-tak

Edit: You need more poll options, lol.

Just added one more, what else were you thinking of? - or were ya taking the pee? I'm guessing the latter knowing you?

[Green Growler]

Just added one more, what else were you thinking of? - or were ya taking the pee? I'm guessing the latter knowing you?

Might have been.....
You could poll wether to have them straight or not.




Ok, I voted small all round, though I would move the 2.0T badge up and put the BSR underneath it.

[Duncan]

Ok, I voted small all round, though I would move the 2.0T badge up and put the BSR underneath it.

I'd then have to move the Signum on the other side up - as well as buy the two new badges, but I would have preferred the small one under the 2.0T, but not an option without redoing the other badges, but maybe something to look at. Might have to get Photochopping to see.

[Green Growler]

Just buy the extra badges, jees your Scottish side shines through sometimes.










PMSL

[Duncan]

LOL, nah it wasn't the cost of them I was meaning. It was the agro of having to remove the current ones, clean all the crap off and then fit the new ones and make sure they're all aligned I was meaning.