Car is Back to Standard

[mark1319]

Thats it back on the standard map now all in preparation for stage 3. The PPC has the stage 3 software on it and I just need to check that it goes onto the car OK then remove it again(No Driving it yet)

Went for a quick drive to confirm it was standard as the previoous 2 times I thought I was doing this all I was doing was reloading stage 1 After a chat with Duncan he told me what I should have been doing. Never read the instructions right

[Duncan]

lol

You'll think the handbrake is on now that you're driving around in standard map!

Just think of what it'll be like when you do get the Stage 3 kit in though. You thought going from standard to Stage 1 brought a smile?!, just wait 'til you go from standard to Stage 3!! I couldn't stop laughing insanely!!!!

[gallag]

cant wait for your review mate. When will it be done

[mark1319]

I can't wait D and if it's all done she'll be running down the strip at PVS.

All going well this Saturday mate, everythings ready to go injectors, exhaust booked the map is on the PPC and I'll test that tomorrow. Just need one more piece of the puzzle to be definate

[FIL 4822]

Yep, Need the full S.P. on what its like after you've used all your fuel !

[signumboy]

Just Got Stage One ,,,jesus Cant Keep The Traction Control Light Off ...more Than Ample For Me

[Duncan]

...Just need one more piece of the puzzle to be definate

I know m8, I'm really working on that one for you. I seriously hope it doesn't hold you up and stop you getting it all done for PVS.

[Steven]

Fingers crossed you get it sorted this weekend bud

As said, any exhaust place worth their salt will be ablt to make the collar for you IMHO

P.S welcome to my world - 180 standard horses

[Duncan]

As said, any exhaust place worth their salt will be ablt to make the collar for you IMHO

Certainly worth asking MIJ about that Mark, it could well be a standard(ish) bit of exhaust kit. The side that attaches to the downpipe is just a 3" external diameter milled 'flange', with the other side that goes into the turbo a curved edge to make the seal.

I have a nasty feeling the bit you're missing may need to come from Sweden, which would bollox things up a bit - I'll find out the latest tomorrow.

[mark1319]

I know m8, I'm really working on that one for you. I seriously hope it doesn't hold you up and stop you getting it all done for PVS.

And very appreciative I am Duncan

Fingers crossed you get it sorted this weekend bud

As said, any exhaust place worth their salt will be ablt to make the collar for you IMHO

P.S welcome to my world - 180 standard horses

She goes like stink now LOL And I'm driving lots of miles this week with it

Certainly worth asking MIJ about that Mark, it could well be a standard(ish) bit of exhaust kit. The side that attaches to the downpipe is just a 3" external diameter milled 'flange', with the other side that goes into the turbo a curved edge to make the seal.

I have a nasty feeling the bit you're missing may need to come from Sweden, which would bollox things up a bit - I'll find out the latest tomorrow.

Yeah if all else fails MIJ should hopefully be able to make it as they make custom downpipes so this should be a normal thing for them.