Air position motor/servo problem !

[Kcs]

Hi all, i have had this problem with my air position motor for
some weeks now, it has a mind of its own ! it seems to move
out of its set position for a second, and then move strait back
again ! VX have changed the motor, but after two days the
symtems came back, if you mess about with the controls, some
of the other motors start to move erratically for a few seconds !
Can anybody point me in the right direction ? my dealer isn't
being helpfull !
thanks
Kcs

[Gsi3.2]

they have changed the servo pack on the air distrubution system and it still cycles away to itself??

it should give body codes if it's got a fault...so i take it, it's not generating any??

[Kcs]

Hi Gsi, not sure they checked for any fault codes !
they just replaced the motor, the one on the right
hand side !

[Gsi3.2]

right.. well perhaps they need to plug it in and see if there's any body codes..as well as seeing what the live data feeds are from the controller..

[Kcs]

Thanks m8 will do, you always feel cheeky telling them
what they should check !

[Gsi3.2]

Nah, not me.....