Any diagams or instructions on how to do this guys??
Cheers mark
Any diagams or instructions on how to do this guys??
Cheers mark
Undo 2 screws in each wheel arch. Pop bonet and take out 2 plastic rivets near lights. Then take out 4 plastic rivets holding bumper to underside of car. Give a sharp pull on each end of the bumper and he bumper will pull away. Lower it down gently being sure to unplug the fog light loom.
Now just undo 3 torx screws holding fog lamps to bumper and remove lamp. Old surrounds just unclip and new ones just clip into place. Then put lamps back on and refit bumper same way as you removed it. HTH
Trust me mate its dead easy, 20 mins tops.
No probs.
No mate, unfortunately, would have been good tough to see how a 2.2 petrol would have held up against a stock 150 cdti.
Totally off topic, but while your here, what is the ideal dilution ratio for brite wheels, 10/1?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks