ive been fitting a handsfree kit to my vectra 2003, 1.8 ls), but im unsure on the mute, if it actually has one. Anyone have a wiring diagram who can tell me?
thanks for any help
ive been fitting a handsfree kit to my vectra 2003, 1.8 ls), but im unsure on the mute, if it actually has one. Anyone have a wiring diagram who can tell me?
thanks for any help
If you have the CDR 2005 then the Tele mute is Pin13 mate. If you have a parrot then you don't need to know this as its all done for you with the parrot loom. HTH
na its a sony ericsson hcb 400. it has no looms as such, so ive got to connect the wiring for myself.
thanks though, will give that a try tomorrow
This might help...
http://www.siocommunications.co.uk/06-115B.html
i can help there
cheers for that.
i hadnt realised the wire wasnt actually there. just gonna leave it for now. I might buy one of those cables as i prefer it coming from the car speakers rather than the the one supplied
Would I be right in thinking that the tel audio in can be taken from the speaker lead that comes out from the car kit that would usually go to a speaker?
Yeah its worth doing you can adjust the volume from headunit controls, works seamless, i added the wired my self and saved on premade for the few wires needed, i good place for the hands free brain is behind the heater controls, lots of space and easy to get to if needed.
Ashtoroth
I'm about to install the Bury car kit, I fitted units before but wanted to see if any could shed some light on a few querys before I start it.
1) The Bury has a speaker with a jack plug on it
- Can this loudspeaker be cut off and wired into the headunit terminals as mentioned above?
2) Do these terminals still exist on the CD30?
3) The microphone wire... is this best run down the passenger A pillar so it doesn't conflict with the airbags?
4) I'm going to use one of these no-damage brackets for the cradle, I.ve seen them on ebay and wanted some advice on fitting location and how to before I start pulling my new dash to pieces.
Thanks in advance for any help...
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks