went to fit my one of these last night but it wasnt having it unless I took the bumper and forced it in... any ideas as how to get it in without breaking the flimsy thing? also I think I have to remove a carrier from either side!?
went to fit my one of these last night but it wasnt having it unless I took the bumper and forced it in... any ideas as how to get it in without breaking the flimsy thing? also I think I have to remove a carrier from either side!?
hi mate,
i didn`t have to take the bumper off to put mine on.....i wrecked the black one when i took it off though!
a good hard push should see it in ..mind you i am a burly 18 stone!
rgds
nev
may have to try it again tonight lol.. was pushing my bumper in and thought i was gonna break bumper.
if it been painted use a stanley knife and scrape the paint off each clip, bit of a pain but should make it easier, try to put something between body and inside of bumper so u can apply a bit more pressure without the bumper flexing
hope this helps
that helps Mr Z, was thinking about sanding it down abit.. trouble is the bumper and the insert have both been sprayed seperate colours so could be excess paint in the actual inserts.
yeh sounds like it, i found that the bumper was really flexing when i push the trim into it then when i packed it out it clipped in really easy
i'll do that then mate
Get it lined up mate then go under the car and prise the clips through by pulling them through from the back of the bumper if you know what i mean as i just fitted this to my car last night!
Clicky here mate!
http://forum.vectra-c.com/showthread.php?t=31506
Last edited by ACE.TAG; 4th October 2007 at 13:31.
Why do you need to do that? as mine was all painted over the clips and i still clipped it in without having smooth them!!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks