centre arm rest broken

[AL21784]

my centre arm rest is broken, one of the plastic bits that hold the runners has snapped, can this be replaced without replacing the whole lot or does it just come as a job lot?
i found the how to guide on how to strip it but can you just get the part thast broken and if so whast the code for it
http://forum.vectra-c.com/showthread.php?t=25796
here's a pic of the broken bits, one side has broken all together abd the other side is on it's way out

[gizmo10119]

I had the armrest replace don an earlier vec of mine, went into the dealers and they came out with just that part so id say that it is av seperatley

[Duncan]

The armrest lid comes as a job lot i.e. all what you've shown in your pic above. Even though it's shown on the parts computer as a number of individual components, they all group together under one part number.

[AL21784]

ahhh bugg£r , any ideas on a part number and a rough price?

[Duncan]

What finish/colour is the cover? Leather? Cloth?

[AL21784]

it's the same on as in the pic above, gray/blackish cloth here's mine

[Duncan]

Trying to work out if it's Steel Grey or Anthracite. Looks like it might be Anthracite. Anthracite is the colour of the plastic trim so if it looks a very close match to that then I'd say it's Anthracite. Can't look at mine to check as I have leather - also in Anthracite confusingly! lol

If it's Steel Grey then 13171935
Anthracite - 13171934

As for cost, sorry no idea.

[AL21784]

cool, thanks.

as the other thread about the buttons around the radio
http://www.vectra-c.com/forum/showthread.php?t=26819
there's plugs behind the covers of the ones i've removed, if i plugged the switches in would they work? see pic . the one at the bottom still covered up does not have a plug behind it

[sonic]

Mine has the plugs as well, but if like mine, yours is a facelift Vec then it is highly unlikely they will work. Something to do with it being a 'full canbus' electrical set up so I'm led to understand!

[AL21784]

Mine has the plugs as well, but if like mine, yours is a facelift Vec then it is highly unlikely they will work. Something to do with it being a 'full canbus' electrical set up so I'm led to understand!

it's the pre facelift veccy, errm 53 plate late 2003