had a nose about on ebay and they seem to have tech 2 units for around 80 quid
are these the 'real' ones and do they do the job?
what does a tech 2 unit look like and what software would i need for an '06 plate 1.8 design
had a nose about on ebay and they seem to have tech 2 units for around 80 quid
are these the 'real' ones and do they do the job?
what does a tech 2 unit look like and what software would i need for an '06 plate 1.8 design
I think this is the correct one pictured below.
You need the one that can interface with CANbus.
You may also need TIS2000 software, not sure though
Stu
Last edited by Stu14t; 19th May 2007 at 09:18.
there is a programe availiable called ''auto enginuity'' by a company called ''gen dan'' that reads all full and half can-bus systems on vx's from 2000 onwards, my dad ( 'tech 2' on here)has it and i think it cost him somewhere in the region of £100.00, they are free to update and do all sorts of other things apart from fault code reading......
hope this is of some use to you all as i said i was going to find out about this for someone else a few weeks ago
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks