-
30th April 2023, 20:00
#1
Vectra is all iver the place
Hi all
ive replaced alot of parts on the car,new coilovers,top mounts,new drive shafts,2 new wishbones,track rod ends,new matching tyres all round and had it in for alignment but when driving and you put your foot on the gas it pulls to the right and when you let off it goes to the left.
all tyre pressure is right,re checked the work and all is tight,its got my head done in,didnt do this with all the old stuff on.
any ideas would be great
tha ks
-
30th April 2023, 20:35
#2
Recheck wish bone bolts most common not done tight enough trust me been there….
-
30th April 2023, 20:41
#3
Originally Posted by
Jon1796
Recheck wish bone bolts most common not done tight enough trust me been there….
checked mate,been over every nut and bolt on it,dont get it
-
30th April 2023, 20:54
#4
Ok go over the 2 bolts that hold rack onto subframe make sure they B….. tight…..
-
are the coilovers set to the same height each side?
-
Post Thanks / Like - 0 Thanks, 1 Likes
-
Had a further look today,all bolts are tight,coilovers are same level all round but i took the under tray off and checked the subframe,well its knackerd,rusted through at the front fixing bolt area,got a new one ordered hopefully thats the cause of the car pulling under load
-
Hope it’s not the the new new on offer flea bay, not worth the money get second hand and sand blast power coated.
-
some guy on the FB page put a pic of his car and the subframe was rotten through, i think it was an Astra though.
What coilovers are they? i had Joms and they were very soft at the rear and made the handling rubbish
Bookmarks