314 brake upgrade

[fewksie]

I've got really bad sticking calipers on my vec T the minute and bought some 314 brakes with Bremen discs and pads for £30. I've cleaned all the calipers down, managed to free the piston out a bit and cleaned that with wet and dry and cleaned up the carrier. Without sounding stupid is it just a matter of stripping the old brakes off and putting the new ones on? The other question was the brake guard. Do I simply cut the lip off with an angle grinder?
Thanks and sorry if the questions have been asked before I did look but couldn't find anything.

Sent from my SM-N950F using Tapatalk

[fatfred]

You just need to cut a small portion of the dust guard. Otherwise yes, just make sure they are up the correct way...... loads of info on here if you search. Best mod after remap I did.

https://www.vectra-c.com/forum/showt...-brake-upgrade

[megsdad]

don't forget that when the calipers are fitted the bleed nipple should be at the top !!

[fewksie]

Thanks both. I've put all new seals in them this week and painted them so going to fit tomorrow all going well shouldn't take long.

Sent from my SM-N950F using Tapatalk