body loom for fitting rear electric windows needed

[yamman]

But had I had more time available I would of went with @plasma retro fit looms as it seems to make things 100% easier and less messy.

[NielsJ]

Did you ever manage to put the wires and pins in the correct place to make it work?? :-D

[yamman]

Hi yes NielsJ i managed to get them done only last week alot easier than i thought i removed seats and all carpets centre consolearound handbrake but that was for future purposes also. Would only need boot side interior trim to get at rec and the side bottom interior plastics both sides to lay wires and rear seat base and carpet removed. If wanted to sure you could thread the wires under seats carpets at front without removing but its easier working with them out. I went from haynes manual wiring diagram and the few threads on here and have layed the body loom now gotta wait for nice day again to do the door looms and motors. Heated seats work now so hoping all rest pins are in correct place. If you go ahead and do it let me know i wrote some stuff down on paper i will put evrything together. But best way is haynes manual and this post by mhvcbv https://www.vectra-c.com/forum/showt...Windows/page20