Clunking on gear change - Engine/Gearbox Mounts?

**Tyler Durden** · 8th December 2018, 10:19

I have a slight clunking on gear change. If I make the car labour by selecting too high a gear it clunks A LOT!

I think I need to replace my engine and/or gearbox mounts. Is there a how to on this?
Also, where would I find the right parts?

Thanks
TD

**northpole** · 8th December 2018, 11:10

autovax, dealers parts counter, eBay or universal places like ECP, GSF, Jayar etc, etc. You actually don't need an how-to for it, if you want to remove a mount, you look at where it is make sure you put a jack under the engine on that particular side, than you replace it... it is that simple.

**Tyler Durden** · 17th June 2019, 20:35

I still have not got round to doing this. Has anyone here done it? Is it as easy as that? .

**Jon1796** · 17th June 2019, 21:47

Yep!!!
Bottom mounts anyway.
And so long as top mounts are sound that’s where it holds engine weight the bottom 2 stop rotation and can be taken off ten minutes for front half hour rear as you’ve got to drop flexi (well on z28net).
Can be done without jack but that’s up to you!!!

Sent from my iPhone using Tapatalk