injector removal

[OLD DOG NEW TRICKS]

Thank you. Did you clean out your engine's breather system too? I am inclined to do mine while it's all apart. That should help it to be oil tight.

Paul

Yes I did I took all the pipes off and breather box , its held on by two torx bolts e8 or e10 iirc it has a gasket on the bottom mine had disintigrated so when I put it back on I used RTV silicone gasket sealer and tightened it back up . Theres some pics in one of my threads somewhere I will try find it for you bud.
All the breather pipes got dumped in really hot soapy water and cleaned out .

[GSiFan]

Cool. I shall do the same to mine. Thank you once again!

Paul

[gixerjd]

yep there just push in and then the rail pushes on and has clips on the top of the injectors then the rails should bolt to the manifold

when rebuilding try putting a little bit of rubber grease round the orings to stop them splitting when pushing them in and makes it easier to put them in aswell

[gixerjd]

yep there just push in and then the rail pushes on and has clips on the top of the injectors then the rails should bolt to the manifold

when rebuilding try putting a little bit of rubber grease round the orings to stop them splitting when pushing them in and makes it easier to put them in aswell

ooops only read the first post on page 1 lol that will teach me to look down the page lol

[OLD DOG NEW TRICKS]

I used dot 4 brake fluid on my O rings as it was suggested by the the firm I got the injector seal kit from.​

[GSiFan]

@OLD DOG NEW TRICKS Paul, how did you get the filter baskets out of the injectors? I am really struggling with mine.

Paul

[shotgun600]

Hello, is it possible to remove the injectors without lifting the intake manifold?