How Easy is it to connect up a rear audio control panel and which headunit ?

[Woody]

Hi guys.

I'm thinking about adding the rear audio controls to my motor.

Is this a relatively "easy" thing to retrofit and is it limited in part to the headunit that is in the car ? (NCDC2013 / CD70 etc)

Cheers

Woody

[rozzer2006]

Pm Sebastian hes done it to his he should sort u out mate ;-)

[Mark-R]

Has yours not got the cables in place my gsi has.

[Caveman_nige]

Dunno about other headunits but I have added it to both my cars which have cd70s fitted

[Woody]

Has yours not got the cables in place my gsi has.

Mine has a NCDC headunit and is pre-face half can. Is it likely to have wiring, or was this only introduced when the likes of CD70's were fitted to fullcan wired cars ?
If it is likely to have the wiring, then where would it be ? I've looked behind the rear ashtray and can't see anything "intriguing" there

[Woody]

Dunno about other headunits but I have added it to both my cars which have cd70s fitted

When you added it Nige, was the wiring already there, or did you have to wire it up and what was involved ?
Was there any programming needed ?

[Mark-R]

Mine is a halfcan preface too mate i will go down and take a pic of mine.

[Mark-R]

Here you go they might be tucked away.

[Woody]

Thanks fella, much appreciated . Going to have a look myself now.

[Mark-R]

Thanks fella, much appreciated . Going to have a look myself now.

Np mate on this thread you can see his cables is tucked down the lft side and its hard to see them.

Edit: oops forgot link lol http://www.vectra-c.com/forum/showth...andbrake-Cable