Indicator Fault

[philc1210]

Hi guys,

I have tried searching within Vectra C for information but for some reason it opens a new page in google and searches that way.

Any way, on to my problem.

For some reason whenever i indicate right the indicator stays on and works as it should, but the second i start to move it turns it self off. I think it is just a faulty switch inside the indicator but would appreciate advice before i spend money.

Thanks in advance
Phil

[Z80]

Hello,

I still have to determine whether the steering action used to turn the indicator off is detected either by the steering angle sensor (located under the car), or some other sensor inside the CIM.

After having playing around with the Op-Com to try and pair my second hand CID, my indicators now refuse to self turn off at all. I did setup the steering wheel sensor again, with no result. The garage did the same with the Tech2, and still no change.

So maybe my CIM is faulty (and so may be yours), or maybe there's a specific setting somewhere I didn't find yet.

Now we have to wait for people having more precise information about it.