gonna give it a go

[stret]

so ive decided im gonna try the led conversion and was after any pointers and tips, wheres a good place to start, what will i need i have a decent solder iron and have just ordered a solder pump tweezers and 100 plcc2 smds, i found a how 2 with window switches and heater control etc is there one for the clocks anywhere

thank

[jazzisri]

biggest advice i can give you is take your time! and use a very small tip, mine was 0.3mm pointed tip on a 30w fixed temp iron I only spent £15 on iron, 2 tips, solder, sucker, tweezers etc and it was absolutely fine. 1 other thing you might need are helping hands, it will hold the board up in the air and stop it getting damaged on or bending the pins on the bottom etc. Other than that good luck lol