Do u know u got a light out lol
Aww dam u noticed lol yeah ano not got any spare so ill need to rewnew it must be a dud there wired in series so av got 3 out qnd yes the polarity is correct lol, bit ragin to be honest lol
Lol they all go to the right check the solder joins on them did u Use plcc2 om there sides trays what I did I've had a couple before where the join of solder not good so breaks off
i put them same polarty as the ones that came off i tryed soldering them a couple of times but no joy, i should have checked every one i put on i only check 3 or 4 a time yeah plcc2, will the plcc 4's work on them av got a few spare, used them for the GID and they were plcc2 standards. if the circut is gubbed ill use telephone wire to wire them up to the ones next to them.
Bit too bright i thought. How does it look when dimmed down to mid and low?
Speedos :-) it is a bit bright to be honest but u get used to it, it does dull down a bit but then the rest is too dull, a will be changing the rest of it so will match :-)
I agree they raw bright mine are aswel my centre screen even brighter lol but as u say u do get used to it. Where did u get your dials from mate here a snap of mine
There are currently 1 users browsing this thread. (0 members and 1 guests)