Changing ccr2006 for NCDC 2013

**bigwilks** · 22nd October 2012, 22:45

Im looking at changing my CCR2006 stereo in my 2003 GSi to a NCDC2013 sat nav system, its from a 2003 GSi Signum but does not have the wiring loom for this or the disc, will my existing wiring loom fit and does anyone have a disc for this model, i also think that this will need to be recoded to work.
Any help or information would be great, many thanks

**BigWilko** · 22nd October 2012, 22:47

OI! don't be posting anything controversial with a username like that!

**paulvectrac** · 22nd October 2012, 22:49

hahahaha confused me abit did that lmfao

**bigwilks** · 22nd October 2012, 22:50

No wonder when i tried to enter that user name it wouldnt let me use it LOL

**paulvectrac** · 22nd October 2012, 22:51

hahahaha wonder who is the biggest wilko fpmsl

**BigWilko** · 22nd October 2012, 22:51

Only room for one BigWilko on here

Go on Paul answer his question

**paulvectrac** · 22nd October 2012, 22:53

o yes lmao yep there is a how to mate some wireing is needed there is a how 2 somewhere i have done a few my self

**bigwilks** · 22nd October 2012, 22:55

ok thanks paul, would you say its a good swap or not? It will cost about £125 to buy then the fitting, how much will a disc cost for it?

**paulvectrac** · 22nd October 2012, 22:57

o yes i have had them in both my cars ncdc with gid in myvectra then ncdc with cid in my siggy and thats cheap 125 although i have the very rare cid in mine

**Robsey** · 22nd October 2012, 23:09

It can be quite a complex modification to carry out. - Depends on how confident you are with wiring and making up looms.

You will need to insert some wires into the main connectors, and also get a 12 pin connector for the display RGB signals.
These 12 pin plugs pop up allover the place in the vectra, such as an instrument cluster plug, light switch plug, door loom plug.
Just get one from a scrap car. - remember to get a decent amount of loom with the connector, to make splicing into the main loom easier.