Flashing Spanner

[Knight Rider]

Went to start the car up after placing out my reverse sensors and control box which I've hooked up to earth and reverse light wire I had the ignition on whilst doing it then went to start the car up up and nothing except a flashing spanner/car symbol. Do you reckon it's just needing a jump start to get it going again after having the ignition on?

[Critch]

Is it turning over?

[Knight Rider]

Is it turning over?

Nothing a tall mate, all my dash lights come on but no turn over

[monty2000]

maybe a longshot but i removed my tcs fuse in attempt to disable the traction and my car wouldnt start.
check the fuses

[Critch]

Not pulled away wires whilst doing it?

Are the dash lights staying bright?

[Knight Rider]

maybe a longshot but i removed my tcs fuse in attempt to disable the traction and my car wouldnt start.
check the fuses

Ok will do

Not pulled away wires whilst doing it?

Just the 2 earth cables underneath the near side brake light for an earthing point but I've tightened them back up again.

Are the dash lights staying bright?

Yes as far as I can see mate.

[Knight Rider]

All fuses have been checked and they're all OK. My voltage gauge on my dash is showing just under 11 so I'm guessing this might be the cause.

[Critch]

More than likely the batt issue of its reading 11v

Gettong a starter relay click when trying?

[Knight Rider]

More than likely the batt issue of its reading 11v

Gettong a starter relay click when trying?

Absolutely nothing mate when I turn the key. Dash does everything it should do when key is in.

[Critch]

Do you have any diagnostics?

Try disconnecting batt for 15 mins