Bought new full size screen (not say nav) to replace half screen with two buttons on it. Any one confirm it'll be a straight swap? Will I need anything to make it work fully?
2006 exclusiv estate 1.9cdti 150.
Thanks :-)
Bought new full size screen (not say nav) to replace half screen with two buttons on it. Any one confirm it'll be a straight swap? Will I need anything to make it work fully?
2006 exclusiv estate 1.9cdti 150.
Thanks :-)
Has it been divorced from the head unit from the donor car? If not you'll need it sorted out by Tech2 mate.
I got proper full verison op-con, how do I get about to do that? As I bought screen from eBay.
Usually, wiring wise - it should be plug and play to fit a Full CAN BID / GID or CID in place of a TID
BID = Board Info Display
CID = Colour Info Display
GID = Graphical Info Display
TID = Triple Info Display (with clock buttons on bezel)
Some people have found that they do not have wires in pins 2 and 3 of the Display connector.
If not, then you need to do as follows: -
Pin 1= brown - link this to pin 2 (ground wire)
Pin 5= red - link this to pin 3 ( CAN controlled Live - fused supply on 5)
Regarding Opcom / Vauxcom - The official comment is that you should speak to Ilexa or Auto3m, as they will provide free customer service and information to official unit (type D interface) owners.
Unofficial versions with type b / b+ interfaces are not discussed on this forum.
However in basic terms: -
You need to get your display in the divorced condition if fitting it with your existing head-unit.
If fitting pre-married display AND head-unit, then no programming should be required.
IF the donor display is still paired to donor vehicle, then you need the donor vehicle's audio pass / car pass number to allow you to divorce it. And even then this does not always work, unless using Tech2 / Tech3 / TIS2Web.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks